5. Roving: The combined or condensed combed sliver is taken to the slubber of a series of machines called roving frames. 6. Spinning: Spinning is a continuation of the roving and on the spinning frame many spools containing the roving pass through the ring spinning mechanism which further draws and twists to a yarn of the required size and twist and winds it on bobbins preparatory to the weaving operation.

Line up the vertical central thread with the centre front line of the stand, and pin. To avoid injury to the fabric, use very fine pins, e.g. silk pins, and keep pinning to a minimum. Temporarily pin the surplus fabric to the side of the stand you are not modeling. Mould the fabric around the stand as desired, allowing the excess fabric to fall freely into the area where you wish the fullness of the drape to be placed. Use drapes in place of darts. The drapes can be continuing along the out edges of the stand and be allowed to fall forwards or back wards into a cascade of drapery or be caught up into a seam line etc., use the grain to experiment for the best effect, numbering that fabric drapes best on the bias. It is some times necessary to control drapes e.g. on a wide neckline could fall off the shoulder or in the case of side panel, where billows might occurs. The following methods are used to control drapes.